Turned Parts Processing Steps

1 Strictly use protective equipment according to the regulations before work, tie up the cuffs, do not wear scarves or gloves, and female workers should wear their hair under the hat. The operator must stand on the foot pedal.
2 The bolts, travel limits, signals, safety protection (insurance) devices, mechanical transmission parts, electrical parts, and lubrication points of each part should be strictly inspected, and they can only be started after they are confirmed to be reliable.
3 The safety voltage and voltage of various machine tool lighting applications shall not exceed 36 volts.
in operation
1 Workers, clips, tools and workpieces must be firmly clamped. All kinds of machine tools should be idling at low speed after starting up, and can only be officially operated after everything is normal.
2 It is forbidden to place tools and other things on the track surface of the machine tool or on the workbench. It is not allowed to remove iron filings by hand, and special tools should be used for cleaning.
3 Observe the surrounding dynamics before starting the machine tool. After starting the machine tool, stand in a safe position to avoid the moving parts of the machine tool and the splashing of iron filings.
4 During the operation of various types of machine tools, it is not allowed to adjust the speed change mechanism or stroke, and it is not allowed to touch the working surface of the transmission part, the workpiece in motion, the cutting tool, etc. during processing, and it is not allowed to measure any size during operation. Partially passing or taking items such as tools.
5 When abnormal noise is found, stop the machine immediately for maintenance, do not run forcibly or with a disease, and the machine tool is not allowed to be used with overload.
6 During the processing of each machine part, strictly implement the process discipline, see the drawings clearly, see the control points of each part, the roughness and the technical requirements of the relevant parts, and determine the production process of the parts.
7 Stop the machine when adjusting the machine speed, stroke, clamping the workpiece and cutting tools, and wiping the machine. It is not allowed to leave the work station when the machine tool is running. When leaving for some reason, you must stop the machine and cut off the power supply.